hast Du einen USB-Linker für die ESCs ?
... zu den Reglern gibt es Anleitungen fürs Peepkonzert,
so oder ähnlich, gibt auch hier irgenwo Anleitung dazu:
Code: Alles auswählen
G. Programming via Transmitter
Step 1: Enter program mode
Switch the transmitter on→Pull the throttle stick to the top position→Switch the ESC on, wait 2 seconds, you will hear two “beep”
sounds, which denotes that Max. throttle has been confirmed→Hold the throttle stick at the top position, and then wait 2 seconds
until you hear tune “♪ 1 2 3 ♪ 1 2 3”, that means you have entered the transmitter programming mode.
Step 2: Select program parameters
Hold the throttle stick on top position, there’re 7 parameters can be set by using your transmitter. You would hear 7 different
indicating sounds which correspond to 7 different parameters. Pull the throttle stick to the bottom position (full Off throttle) within
2 seconds after you hear the correspondent sound will brings you to the correspondent parameter setting status. The indicating
sounds will repeat in turn as follow.
1. “beep-” (a short sound) which indicates the Brake Type
2. “beep-beep-” (two short sounds) which indicates the Timing Mode
3. “beep-beep-beep-” (three short sounds) which indicates the Start Force
4. “beep-beep-beep-beep-” (four short sounds) which indicates the Curve Mode
5. “beep-----” (a long sound) which indicates the Control Frequency
6. “beep-----beep-” (a long sound and a short) which indicates the Low-voltage Protection
7. “beep-----beep-beep-” (a long sound and two short) which indicates the Cutoff Mode
8. “beep-----beep-beep-beep-” (a long sound and three short) which indicates the Rotation Direction
Step 3: Select program values
After entering parameter setting status, hold the throttle stick on the bottom position, you will be led to the repeat selection of that
parameter setting status. Each sound likes 4 short sounds and one long sound (1 long sound=5short sounds), and by that analogy.
After some sound, pull the throttle stick to the top position in 2 seconds, after you hear a tune “♪3 2 1 ♪3 2 1”, which means the
correspondent value has been chosen and saved. Hold the stick on the top position, return to the second step and continue
programming.
Step 4: Exit program
Pull the throttle stick to the bottom position within 2 seconds and hold on after saving parameters, until you hear a tune “beep----
beep- beep- beep- ♪ 1 2 3”. Set the Min. Throttle at this moment and exit program and operate as normal.(beep----means Loading
parameter. beep- beep- beep-means numbers of cells and ♪1 2 3 means ready. )
Restore Factory settings
To restore Factory settings, pull the throttle stick to the bottom position (full Off throttle ) within 1s after entering program mode
(Step 1)→Pull the throttle stick to the top position within 2s, then you will hear a tune, which means that the factory settings have
been restored. Pull the throttle stick to the bottom position within 2s, the ESC is ready with factory settings.